化工儀器網
資料下載
Nanobrook Omni測量應用案例-91
閱讀：189 發布時間：2019-4-4| 提 供 商 | 美國布魯克海文儀器公司 | 資料大小 | 1.3MB |
|---|---|---|---|
| 資料圖片 | 下載次數 | 34次 | |
| 資料類型 | PDF 文件 | 瀏覽次數 | 189次 |
| 免費下載 | 點擊下載 |
作者：Mari Cruz G. Saborío,1,2 Frances Estrany,1,2 and Carlos Alemán1,2
1 Departament d’Enginyeria Química, EEBE, Universitat Polite?cnica de Catalunya, C/ Eduard Maristany, 10-14, Ed. I2, 08019, Barcelona, Spain
2 Barcelona Research Center for Multiscale Science and Engineering, Universitat Politècnica de Catalunya, Eduard Maristany, 10-14, 08019, Barcelona, Spain
摘要：Composites formed by poly(3,4‐ethylenedioxythiophene) and alumina (PEDOT/Al2O3) have been prepared by in situ anodic polymerization. For this purpose, the stability of 1:1 and 4:1 monomer:alumina aqueous solutions has been examined as a function of the pH (2.3, 4.0, 7.0, 8.8, or 10.8). Results indicate that the monomer behaves as a dispersant that remains stable at the studied basic pHs despite they are close to the isoelectric point of alumina. Although the thermal stability of the composites is considerably affected by the pH of the reaction medium, its influence on the surface morphology is very small. Independently, of the synthetic conditions, the electrochemical properties were better for PEDOT/Al2O3 than for pure PEDOT, reflecting that alumina particles promote the charge mobility. The highest specific capacitance (SC; 141 F/g), which was 55% higher than that obtained for pure PEDOT, was achieved for the composite prepared at pH = 8.8 using a 4:1 monomer:alumina ratio. These conditions favor the participation of OH– groups as secondary doping agents without degrading the polymer matrix and enhance the specific surface of the films, facilitating the ionic mobility. On the other hand, application of a multi‐step polymerization strategy has shown that interfaces originated by consecutive steps enhance the SC.