化工儀器網
產品簡介
Ossila材料PFO CAS:19456-48-5[Ossila*、交期準時、歡迎新老客戶，更多產品資料請我司銷售】
詳細介紹
只用于動物實驗研究等
Poly(9,9-di-n-octylfluorenyl-2,7-diyl), known as F8 or PFO, is a polyfluorene specifically optimised for a variety of organic electronic applications.
General Information
| Full name | Poly(9,9-di-n-octylfluorenyl-2,7-diyl) |
| Synonyms |
|
| Chemical formula | (C29H41)n |
| CAS number | 19456-48-5 |
| Recommended solvents | Toluene, xylene, chlorobenzene |
| Classification / Family | Polyfluorenes, Benzothiodiazoles, Organic semiconducting materials, Semiconducting polymers, OLED green emitter materials, OLED materials, Organic Photovoltaic materials, Polymer solar Cells, OFET materials |
Batch Details
| Batch number | MW | MN | PDI |
|---|---|---|---|
| M161 | 114,050 | 37,910 | Out of stock |
| M162 | 85,983 | 31,040 | 2.77 |
Chemical structure of PFO (F8). CAS No.: 19456-48-5. Chemical formula: (C29H41)n.
Characterisation
F8 distribution plot.
Applications
For a high-efficiency green OLED we recommend blending F8 with F8BT with the below specifications. This ink can then be applied either in air, or in a glovebox, with little difference in performance (provided exposure time and light levels are minimised). For more details see our fabrication guide.
Ossila材料PFO CAS:19456-48-5
At typical concentrations of 10 mg/ml, 100 mg of F8 (PFO) will make around 200 devices on Ossila's standard ITO substrates (20 x 15 mm), assuming 50% solution usage (50% loss in filtering and preparation).
OLED reference device:
- F8 with F8BT
- Blend ratio of 19:1 (F8:F8BT) in Toluene
- Total concentration of 10 mg/ml
- 0.45 μm PTFE filter
- Spun at 2000 rpm (approx. 70 nm thickness)
Ossila材料PFO CAS:19456-48-5
Pipetting 20 μl of the above solutions onto a substrate spinning at 2000 rpm should provide a good even coverage, with approximay 70 nm thickness. The substrate needs to be spun until dry, which is typically only a few seconds — 15 seconds should be ample to achieve this. Thermal annealing should be undertaken at 80°C for 10 minutes prior to cathode deposition.
Typical device architectures and performance
A basic, efficient OLED can be made using PEDOT:PSS as a hole-transport layer and Calcium/Aluminium as the electron contact. When used with the Ossila ITO substrates and shadow masks this produces an easy to fabricate yet efficient >100 cd/m2) device.
